Fix-A-Floor® Adhesive & Residue Remover — Step-By-Step Application Guide

This guide walks you through the proper safety precautions and application process for effectively removing leftover adhesive and residue after tile repairs with Fix-A-Floor Adhesive & Residue Remover. Follow each step closely for optimal performance.

Safety Precautions (Before You Begin)

1. Ensure Proper Ventilation and Personal Protection
• Work in a well-ventilated area to avoid inhaling fumes.
• Wear chemical-resistant gloves and protective eyewear to prevent skin or eye contact with the solution.

Application Instructions

1. Spot Test
2. • Before full application, test the product on an inconspicuous area of the surface to confirm compatibility and check for any adverse reaction.
   • Follow the same method as the full application when testing and allow time to observe the results before proceeding.
3. Apply the Remover
   • Apply Fix-A-Floor® Adhesive & Residue Remover directly onto the adhesive or residue.
   • For small areas or targeted applications, you may also apply the product to a clean, dry cloth and spread evenly over the surface.
   • For tougher or dried-on residues, allow the solution to penetrate for 2–4 minutes before scrubbing. Do not let the solution dry on the surface.

3. Scrub and Lift
• Using a damp sponge, gently scrub the treated area to lift and loosen the adhesive or residue from the tile or flooring surface.
• Reapply as needed for thick or stubborn spots, always working in small sections for best control.
4. Final Wipe and Buff
• Once the residue has been removed, wipe the surface clean with a dry cloth.
• Buff the area thoroughly to remove any remaining film or moisture, leaving a clean, residue-free finish.

Limitations

• Avoid damage or unwanted results. Do not use this product on the following materials:
  • Rubber or PVC surfaces
  • Unfinished wood
  • Unglazed tile
  • Unsealed stone or concrete
• Do not allow the solution to fully dry on any surface, as this may lead to staining or surface damage.
• Do not exceed the recommended dwell time of 2–4 minutes on any application area.